ºÚÁÏרÇø

Sparklike is the industry leader in developing non-destructive gas fill measurement devices for insulating glass windows and doors. Our devices, such as and , enable measuring of the gas with ease and without having to break the glass unit.

It is important to calibrate your Sparklike deviceâ„¢ regularly to maintain reliability. The main reason for calibration is to confirm the accuracy and precision of the instrument, and to ensure the readings are consistent with other measurements. The accuracy and precision of all measuring devices degrades over time.

There is a fundamental difference between calibration of electromechanical and mechanical measuring devices. Due to the nature of electronic components, the circuits can drift slowly and develop offsets in proportion with their use and time. This is typical with wear and tear of components in electromechanical measuring devices.

always includes component replacement when necessary, tuning and adjustments. The circuits are designed with the necessary trimmers/potentiometers so that adjustments can be made as needed. Finally, the operating software running the measurement process will have new parameters based on the adjustment process. Performing this procedure improperly may harm the device. The hidden costs and risks associated with unauthorized alterations to any Sparklike deviceâ„¢ could be much higher than the cost of authorized calibration service.

When should you calibrate your measuring device?

• After any substantial mechanical impact or electrical shock
• Repeated indeterminate results in successive measurements
• Required by the end users (Customer) quality program and procedures
• According to the recommendation of the manufacturer

To ensure the accuracy and precision of the instrument Sparklike deviceâ„¢ must be calibrated annually.

Sparklike has adopted a six-point calibration procedure as the standard method for the and a nine-point calibration procedure for the devices. All required adjustments are based on the calibration and can only be completed by authorized Sparklike Calibration Centers.

The above is valid for both the Handheld and Laser products. 

What is done in the Sparklike calibration service procedure:

• General condition check, accuracy check
• Necessary components replaced (deteriorating during use and time)
• Adjustment of the measuring electronics 
• Adjustment of mechanical actuators and optical accuracy
• Software updates and upgrades
• Verification of the operation and measuring results with Sparklike's certificated procedure
• Issuing a Calibration Certificate

Contact us below to calibrate your Sparklike deviceâ„¢